Promo! Save 64% on VarseoSmile Crown Plus Printing Services – Alien Milling Technologies
Black Friday Deals on Now!
Cart 0

Promo! Save 64% on VarseoSmile Crown Plus Printing Services

Huge Markdown! SAVE 64% on VarseoSmile Crown plus Printing Services!
Promo ends 03/31/2021

The tooth-colored ceramic filled hybrid material for 3D printing of permanent single crowns, inlays, onlays, and veneers

Advantages for the laboratory

  • Specially for the resin developed printing and processing parameters ensure smooth production sequences with reproducible results at any time
  • High dimensional stability and strength of the printed objects due to high values of flexural strength and flexural modulus – therefore precise fit
  • Minimized resin sedimentation for easy handling, no mixing or shaking necessary with regular use
  • Easy to grind and polish by using standard tools
  • Seven shades according to the proven VITA* classical shades:
    A1, A2, A3, B1, B3, C2, D3
  • Satisfies all the requirements for a Class IIa** medical device

Advantages for the patient

  • Excellent aesthetics thanks to a balanced ratio of opacity and translucency
  • Low tendency to age and discolor thanks to very low water absorption
  • Low plaque accumilation due to smooth surface
  • High comfort thanks to low cold and heat sensitivity
  • Antagonist-friendly material with mechanical buffering effect – ideal for implant-supported crowns
  • Minimized formation of secondary caries thanks to a high adhesive bond with luting composites
  • High biocompatibility due to very low water solubility – therefore not cytotoxic, not genotoxic, not toxic, not irritating, and not sensitizing

INDIVIDUALIZATION WITH STAINS

The individualization of the post-cured objects is possible with composite stains and is the responsibility of the user. Follow manufacturer‘s instructions.

NOTE FOR PRACTITIONERS

VarseoSmile Crown plus can be attached using self-adhesive cements (e. g. RelyX Unicem*, 3M Espe*) or composite cement with a primer (e. g. Variolink Esthetic DC* and Monobond Plus*, Ivoclar Vivadent*). Observe the instructions for use of the luting agent.

LIGHT-CURING

The light polymerization can be achieved with the BEGO Otoflash (two xenon stroboscopic lamps, flash frequency 10 Hz, light spectrum 300 – 700 nm) or with the HiLite Power*, Fa. Heraeus Kulzer* (one xenon stroboscope lamp, flash frequency 20 Hz, light spectrum 390 – 540 nm).



Older Post Newer Post


Leave a comment

Please note, comments must be approved before they are published